Users Guide

The global AirGroup status must be enabled on the controller to enable AirGroup IPv6 support. For more information,
see AirGroup IPv6 Support on page 1038.
8. Under Global Setting > AirGroup CPPM query interval, enter a value in the range of 1 to 24 hours.
The default value is 10. For more information on AirGroup CPPM query interval, see Configuring the CPPM
Query Interval on page 1057.
9. Under Global Setting > AirGroup location discovery, select enable from the drop-down list.
If enabled, AirGroup user can discover shared devices based on the user’s proximity to the AirGroup server.
If disabled, location based filtering does not apply. Users can discover far servers. For more information on
location attributes in CPPM, see Table 230.
10.Under Global Setting > AirGroup Active Wireless Discovery, select enable from the drop-down list.
If enabled, AirGroup controller actively sends refresh requests to discover wireless servers. If disabled, the
controller sends refresh requests to wired AirGroup servers only.
11.Click Apply.
AirGroup CPPM enforce registration, AirGroup CPPM query interval, AirGroup location discovery, and
AirGroup Active Wireless Discovery parameters are available on the master controller only. The master controller
pushes these configurations to all the applicable local controllers.
Table 230 shows the location attributes a device can register with CPPM and the corresponding behavior on
the controller:
Location Attribute Tag=Value Format Description
AP-Name based ap-name=<name> When the location is set to ap-name, all AirGroup
users connected to this AP and other APs that are
in the same RF neighborhood can access the
shared device.
AP-Group based ap-group=<group> When the location attribute is set to ap-group, all
AirGroup users associated to the APs in the
specified AP group can access the shared device.
AP-FQLN based fqln=<fqln> When the location attribute is set to ap-FQLN, all
AirGroup users connected to APs on the same
floor, and to the APs on a floor above or below the
configured APs can access the shared device.
Table 230: Location Attributes in CPPM
In the CLI
Access the controller’s command-line interface and use the following command to enable or disable the
AirGroup Global Setting:
(host) (config) #airgroup {enable | disable}
(host) (config) #airgroup cppm-server enforce-registration
(host) (config) #airgroup ipv6
(host) (config) #airgroup query-interval <1..24>
(host) (config) #airgroup location-discovery {enable | disable}
(host) (config) #airgroup active-wireless-discovery {enable | disable}
Dell Networking W-Series ArubaOS 6.4.x | User Guide AirGroup |
1047