Release Notes

679 | rf dot11g-radio-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
maximum-distance
Maximum distance between a
client and an AP or between a
mesh point and a mesh portal, in
meters. This value is used to derive
ACK and CTS timeout times. A
value of 0 specifies default settings
for this parameter, where timeouts
are only modified for outdoor
mesh radios which use a distance
of 16km.
The upper limit for this parameter
varies, depending on the 20/40
MHz mode for a 2.4GHz frequency
band radio:
l 20MHz mode: 54km
l 40MHz mode: 24km
Note that if you configure a value
above the supported maximum,
the maximum supported value will
be used instead. Values below
600m will use default settings.
0-24km
(40MHz
mode)
0-54km
(20MHz
mode)
0 meters
mgmt-frame-throttle-
interval
Averaging interval for rate limiting
management frames in seconds.
Zero disables rate limiting.
Note: This parameter only applies
to AUTH and ASSOC/RE-ASSOC
management frames.
0-60 1 second
interval
mgmt-frame-throttle-limit
Maximum number of management
frames allowed in each throttle
interval.
NOTE: This parameter only applies
to AUTH and ASSOC/RE-ASSOC
management frames.
0-999999 20 frames
per interval
mode
One of the operating modes for the
AP.
ap-mode
ap-mode
Device provides transparent,
secure, high-speed data
communications between wireless
network devices and the wired
LAN.
am-mode
Device behaves as an air monitor
to collect statistics, monitor traffic,
detect intrusions, enforce security
policies, balance traffic load, self-
heal coverage gaps, etc.
spectrum-mode
Device operates as an spectrum
monitor, and can send spectrum
analysis data to a desktop or
laptop client.