Release Notes

653 | rf arm-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Syntax
Parameter Description Range Default
<profile>
Name of this instance of the profile. The
name must be 1-63 characters.
— “default”
40MHz-allowed- bands
The specified setting allows ARM to
determine if 40 MHz mode of operation
is allowed on the 5 GHz or 2.4 GHz
frequency band only, on both frequency
bands, or on neither frequency band.
All/None/
a-only/g-only
a-only
All
Allows 40 MHz channels on both the 5
GHZ (802.11a) and 2.4 GHZ (802.11b/g)
frequency bands.
— —
None
Disallows use of 40 MHz channels.
— —
a-only
Allows use of 40 MHz channels on the 5
GHZ (802.11a) frequency band only.
— —
g-only
Allows use of 40 MHz channels on the
2.4 GHZ (802.11b/g) frequency band
only.
— —
80MHz-support
If enabled, 80 MHz channels can be used
in the 5GHz frequency band on APs that
support 802.11ac.
— enabled
acceptable-coverage-index
The minimal coverage that the AP
should try to achieve on its channel. The
denser the AP deployment, the lower
this value should be.
This setting applies to multi-band
implementations only.
1-6 4
active-scan
When active-scan is enabled, an AP
initiates active scanning via probe
request. This option elicits more
information from nearby APs, but also
creates additional management traffic
on the network. This feature is disabled
by default, and should not be enabled
except under the direct supervision of
Dell Technical Support.
Default: disabled
—
disabled
aggressive-scan
When this feature is enabled, an AP radio
with no clients will scan channels every
second.
— enabled
assignment
Activates one of four ARM
channel/power assignment modes.
— single-band
(new
installations
only)
disable
Disables ARM channel/power
assignments.
— —