Release Notes

Parameter Description
UDP
Run Iperf tests using the UDP protocol.
bandwidth <value>
Rate at which the Iperf test data should be sent, in bits/sec. The default value
is 1 Mbit/sec. This parameter supports the suffixes K (to represent Kbits/sec)
and M (to represent Mbits/sec.)
duration
Number of seconds for which the test runs. The supported range is 10-120
seconds, and the default value is 10 seconds.
parallel
Number of parallel clients threads to run.
window
TCP window size. This parameter supports the suffixes K (to represent Kbit-
s/sec) and M (to represent Mbits/sec.)
port open|close
Use this command under the guidance of Dell technical support to open
port 5001 to allow Iperf throughput tests between the controller and
the AP.
Usage Guidelines
Only W-AP130 Series, W-AP220 Series, and W-AP105 access points connected to a W-7200 Series or W-
6000M3 controller support this feature. The report generated by an Iperf throughput test can be viewed by
issuing the command .
Related Commands
Command Description
show perf-test reports Use this command under the guidance of Delltechnical support to view the results of
an Iperf throughput test launched from the controller.
Command History
Introduced in ArubaOS 6.3.
Command Information
Platforms Licensing Command Mode
W-6000M3 controllers Base operating system Enable mode on master or local
controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide perf-test | 592