Reference Guide

1242 | show rf optimization-profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
RSSI Check Frequency 0 sec
The output of this command includes the following parameters:
Parameter Description
Station Handoff
Assist
If enabled, this parameter allows the controller to force a client off an AP when the RSSI
drops below a defined minimum threshold.
Detect Association
Failure
Shows if the profile enables or disables STA association failure detection.
Coverage Hole
Detection
Shows if the profile enables or disables coverage hole detection.
Hole Good RSSI
Threshold
Time, in seconds, after a coverage hole is detected until a coverage hole event notification is
generated.
This parameter requires the RF Protect license.
Hole Good Station
Ageout
Stations with signal strength above this value are considered to have good coverage.
This parameter requires the RF Protect license.
Hole Detection
Interval
Time, in seconds, after which a station with good coverage is aged out.
This parameter requires the RF Protect license.
Hole Idle Station
Ageout
Time, in seconds, after which a station in a poor coverage area is aged out.
This parameter requires the RF Protect license.
Hole Poor RSSI
Threshold
Stations with signal strength below this value will trigger detection of a coverage hole.
This parameter requires the RF Protect license.
Detect interference
Enables or disables interference detection.
Interference
Threshold
Percentage increase in the frame retry rate (FRR) or frame receive error rate (FRER) before
interference monitoring begins on a given channel.
Interference
Threshold Exceed
Time
Time, in seconds, the FRR or FRER exceeds the threshold before interference is reported.
Interference
Baseline Time
Time, in seconds, the air monitor should learn the state of the link between the AP and client
to create frame retry rate (FRR) and frame receive error rate (FRER) baselines.
RSSI Falloff Wait
Time
Time, in seconds, to wait with decreasing RSSI before a deauthorization message is sent to
the client. The maximum value is 8 seconds.
Low RSSI Threshold
Minimum RSSI above which deauthorization messages should never be sent.
RSSI Check
Frequency
Interval, in seconds, to sample RSSI.
Command History
Version Modification
ArubaOS 3.0 Base operating system
ArubaOS 3.4 Output parameters displaying load balancing status were removed. You can now view
the status of the load balancing feature via the commands show rf dot11a-radio-profile
and show rf dot11g-radio-profile.