Reference Guide

740 | show ap spectrum ap-list Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Examples
The output of this example shows spectrum data seen by spectrum monitor ap123. The output in the example
below has been divided into two tables to better fit this document. In the ArubaOS CLI, the output appears as a
single, long table.
The output of this command includes the following information:
(host)# show ap spectrum ap-list ap-name ap123
Spectrum AP Table
-----------------
bssid essid spectrum-id chan phy-type signal(dBm)
----- ----- ----------- ---- -------- ---------------
00:0b:86:cd:22:d0 ECSD Wireless 2 161 80211a 62
00:0b:86:cb:cf:30 ECSD Wireless 3 157 80211a 68
00:0b:86:f6:f6:a0 osuwireless 3 1 80211b/g 48
00:0b:86:f6:f6:a1 osuvoice 4 1 80211b/g 47
00:0b:86:f6:f6:a2 osuguest 5 1 80211b/g 45
avg-rssi(dB) curr-rssi(dB) ibss add-time last-seen
-------- --------- ---- -------- -----------
29 31 no 2010-05-16 17:41:36 2010-05-18 13:39:38
24 25 no 2010-05-16 17:41:36 2010-05-18 14:19:03
37 38 no 2010-05-16 17:41:36 2010-05-18 15:06:02
38 38 no 2010-05-16 17:41:36 2010-05-18 15:04:23
37 40 no 2010-05-16 17:41:36 2010-05-18 15:07:32
Column Description
bssid Basic Service Set Identifier for an AP. This is usually the AP’s MAC address.
essid Extended service set identifier that names a wireless network.
spectrum-id Identifier assigned to the device by the spectrum monitor
chan Radio channel used by the BSSID
freq-band Radio phy type. Possible types include:
 2.4 GHz
 5 GHz
signal (dBm) Strength of the signal received by the device, in dBm.
avg-rssi The average signal-to-noise ratio seen by the AP.
curr-rssi Most recent signal-to-noise ratio seen by the AP.
ibss Shows if ad-hoc BSS is enabled or disabled. It is enabled if the bssid has detected an ad-
hoc BSS (an ibss bit in an 802.11 frame).
add-time Time when the AP was first detected by the spectrum monitor.
last-seen Time when the AP was last seen by the spectrum monitor.