Reference Guide

Table Of Contents
Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show ap details | 675
USB Device Type The USB driver type.
USB Device Identifier The USB device identifier.
USB Dial String The dial string for the USB modem.
USB Initialization String The initialization string for the USB modem.
USB TTY device path The TTY device path for the USB modem.
Mesh Role If the mesh role is “none,” the AP is operating as a thin AP. An AP operating as a mesh
node can have one of two roles: mesh portal or mesh point.
Installation The type of installation (indoor or outdoor). The default parameter indicates that the
ArubaOS automatically selects an installation mode based upon the AP’s model type.
Latitude Latitude coordinates of the AP, in the format Degrees Minutes Seconds (DMS).
Longitude Longitude coordinates of the AP, in the format Degrees Minutes Seconds (DMS).
Altitude Altitude, in meters, of the AP. This parameter is supported on outdoor APs
only.
Antenna bearing for
802.11a
Horizontal coverage distance of the 802.11a (5GHz) antenna from true north, from 0-360
degrees.
NOTE: This parameter is supported on outdoor APs only. The horizontal coverage
pattern does not consider the elevation or vertical antenna pattern.
Antenna bearing for
802.11g
Horizontal coverage distance of the 802.11g (2.4GHz) antenna from true north, from 0-
360 degrees.
NOTE: This parameter is supported on outdoor APs only. The horizontal coverage
pattern does not consider the elevation or vertical antenna pattern.
Antenna tilt angle for
802.11a
The angle of the 802.11a (5GHz) antenna. This parameter can range from between -90
degrees and 0 degrees for downtilt, and between +90 degrees and 0 degrees for uptilt.
Antenna tilt angle for
802.11g
The angle of the 802.11g (2.4GHz) antenna. This parameter can range from between -90
degrees and 0 degrees for downtilt, and between +90 degrees and 0 degrees for uptilt.
Mesh SAE Shows if the AP has enabled or disabled Secure Attribute Exchange (SAE) on a mesh
network. This setting is disabled by default.
Column Description