Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show ap debug client-stats | 641
Frames Transmitted Number of frames successfully transmitted.
Success With Retry Number of frames that were transmitted after being retried.
Tx Mgmt Frames Number of management frames transmitted.
Tx Probe Responses Number of transmitted probe responses.
Tx Data Frames Number of transmitted data frames.
Tx CTS Frames Number of clear-to-sent (CTS) frames transmitted.
Dropped After Retry Number of frames dropped after an attempted retry.
Dropped No Buffer Number of frames dropped because the AP’s buffer was full.
Missed ACKs Number of missed acknowledgements (ACKs)
Long Preamble Number of frames sent with a long preamble.
Short Preamble Number of frames sent with a short preamble.
Tx EAPOL Frames Number of Extensible Authentication Protocol over LAN (EAPOL) frames transmitted.
Tx <n> Mbps Number of frames transmitted at <n> Mbps, where <n> is a value between 6 and 300.
Tx WMM Number of Wifi Multimedia (WMM) packets transmitted for the following access categories. If
the AP has not transmitted packets in a category type, this data row will not appear in the
output of the command.
Tx WMM [BE]: Best Effort
Tx WMM [BK]: Background
Tx WMM [VO]: VoIP
Tx WMM [VI]: Video
UAPSD OverflowDrop Number of packets dropped due to Unscheduled Automatic Power Save Delivery (U-APSD)
overflow.
Last SNR The last recorded signal-to-noise ratio.
Last SNR CTL0 The signal-to-noise ratio for the last received data packet on the primary (control) channel 0.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR CTL1 The signal-to-noise ratio for the last received data packet on the secondary (control) channel
1. This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR CTL2 The signal-to-noise ratio for the last received data packet on the secondary (control) channel
2. This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR Signal-to-noise ratio for the last received ACK packet.
Last ACK SNR CTL0 Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 0. This
parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL1 Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 1. This
parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL2 Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 2. This
parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR EXT0 Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel 0.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR EXT1 Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel 1.
This parameter is only displayed for APs operating in 40 Mhz mode.
Frames Received Number of frames received.
Rx Data Frames Number of data frames received.
Parameter Description