Reference Guide

628 | show ap database Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Syntax
Usage Guidelines
Many of the parameters in this command can be used together to filter a large database of information down to
just the AP data you want to see. For example, you can issue the command show ap database group <group>
Parameter Description
group <group> Show data for a specified AP group.
inactive Show only local APs with no active BSSIDs or wired
AP interfaces.
indoor Show only APs that have an installation mode set to “indoor.”
local Show only APs on this controller.
long Display the following additional data columns:
 Wired MAC Address,
 Serial #
 Slot/Port
 FQLN
outdoor Show only APs that have an installation mode set to “outdoor.”
page <page> Display a limited number of APs by entering the number of APs to be displayed
in the output of this command.
sensors Show only RFprotect sensors.
disconnected Show only disconnected RFprotect sensors.
sort-by Sort the output of this command by a specific data column.
ap-group Sort by AP group name.
ap-ip Sort by AP group name.
ap-type Sort by AP model.
fqln Sort by Fully Qualified Location Name (FQLN).
provisioned Sort by provisioning statistics.
status up|down If used with the sort-by keyword, status sorts the output of the command by
status type (up or down.) Otherwise, use the status keyword to display APs
with the specified status.
switch-ip Sort by controller IP address.
sort-direction Choose sort direction of AP list:.
ascending Sort AP list in ascending order by name.
descending Sort AP list in descending order by name.
start <start> Start showing the AP index at the specified index number.
status Show only APS with a given status as active or inactive.
down Show only APs that are inactive.
up Show only APs that are active.
switch <switch-ip-addr> Show only APs registered with a specified controller by entering a controller
IP address.
unprovisioned Show only unprovisioned APs (using modifiers).