Reference Guide

Table Of Contents
Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide Introduction | 3
Introduction
The ArubaOS command line interface (CLI) allows you to configure and manage your controllers. The CLI is
accessible from a local console connected to the serial port on the controllers or through a Telnet or Secure Shell
(SSH) session from a remote management console or workstation.
What’s New In ArubaOS 6.1
The following commands have been added in the ArubaOS 6.1 command line interface.
NOTE: Telnet access is disabled by default. To enable Telnet access, enter the telnet cli command from a serial connection or an
SSH session, or in the WebUI navigate to the Configuration > Management > General page.
Command Description
clear wms wired-mac Clear learned and collected Wired MAC information.
cluster-member-custom-
cert
This command sets the controller as a control plane security cluster root, and
specifies a custom user-installed certificate for authenticating cluster members
cluster-member-factory-
cert
This command sets the controller as a control plane security cluster root, and
specifies a custom user-installed certificate for authenticating cluster members.
controller-ipv6 This command sets the default IPv6 address of the controller to the IPv6 loopback
interface address or a specific VLAN interface address.
crypto-local ipsec sa-
cleanup
Issue this command to clean IPsec security associations (SAs).
crypto-local isakmp
certificate-group
Issue this command to configure an IKE Certificate Group for VPN clients.
crypto-local isakmp sa-
cleanup
This command enables the cleanup of IKE SAs.
crypto-local isakmp xauth This command assigns the server certificate used to authenticate the controller for
VPN clients using IKEv2.
ip igmp Added parameters: max-members-per-group and quick-client-
conver
interface vlan ipv6
address
This command configures the link local address or the global unicast adress for this
interface.
ipv6 cp-redirect-address This command configures a redirect address for captive portal.
ipv6 default-gateway This command configures an IPv6 default gateway.
ipv6 mld This command configures the IPv6 MLD(Multi-listener discovery) parameters.
ipv6 neighbor This command configures an IPv6 static neighbor on a VLAN interface.
ipv6 route This command configures static IPv6 routes on the controller.
local-custom-cert This command configures the user-installed certificate for secure communication
between a local controller and a master controller.