Reference Guide

134 | ap-group Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Usage Guidelines
AP groups are at the top of the configuration hierarchy. An AP group collects virtual AP definitions and
configuration profiles, which are applied to APs in the group.
Example
The following command configures a virtual AP profile to the “default” AP group:
(host)(config) #ap-group default
virtual-ap corpnet
Related Commands
View AP group settings using the command show ap-group.
Command History:
Command Information
no Negates any configured parameter. — —
regulatory-domain-
profile
Configures the country code and valid channels. See “ap
regulatory-domain-profile” on page 114.
— “default”
rf-optimization-
profile
Configure coverage hole and interference detection. See
“rf optimization-profile” on page 484.
— “default”
virtual-ap One or more profiles, each of which configures a specified
WLAN. See “wlan virtual-ap” on page 1330.
— “default”
voip-cac-profile Configures voice over IP (VoIP) call admission control (CAC)
options. See “wlan voip-cac-profile” on page 1336.
This parameter requires the PEFNG license.
— “default”
wired-ap-profile Configures the second Ethernet port (enet1) on the AP. See
“ap wipe out flash” on page 126.
— “default”
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Support for the mesh parameters was introduced
ArubaOS 3.4.1 The voip-cac-profile parameter required the PEF license.
ArubaOS 5.0 The voip-cac-profile parameter requires the PEFV license.
ArubaOS 6.0 The enet-port-profile parameters parameters were introduced.
Platforms Licensing Command Mode
All platforms Base operating system, except for
noted parameters
Config mode on master controllers
Parameter Description Range Default