Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide wlan ssid-profile | 1325
wpa2-psk-tkip WPA2 with TKIP encryption using a preshared key.
wpa2-tkip WPA2 with TKIP encryption and dynamic keys using 802.1x.
wpa-psk-aes WPA with AES encryption using a preshared key.
wpa2-psk-tkip WPA2 with TKIP encryption using a preshared key.
wpa2-tkip WPA2 with TKIP encryption and dynamic keys using 802.1x.
xSec Encryption and tunneling of Layer-2 traffic between the controller and
wired or wireless clients, or between controllers. To use xSec encryption,
you must use a RADIUS authentication server. For clients, you must install
the Funk Odyssey client software.
Requires installation of the xSec license. For xSec between controllers,
you must install an xSec license in each controller.
qbss-load-
enable
Enables the AP to advertise the QBSS load element. The element includes
the following parameters that provide information on the traffic situation:
 Station count: The total number of stations associated to the QBSS.
 Channel utilization: The percentage of time (normalized to 255) the
channel is sensed to be busy. The access point uses either the
physical or the virtual carrier sense mechanism to sense a busy
channel.
 Available admission capacity: The remaining amount of medium time
(measured as number of 32us/s) available for a station via explicit
admission control.
The QAP uses these parameters to decide whether to accept an
admission control request. A wireless station uses these parameters to
choose the appropriate access points.
NOTE: For 802.11n APs, ensure that either wmm or high throughput is
enabled.
— disabled
rts-threshold
Wireless clients transmitting frames larger than this threshold must issue
Request to Send (RTS) and wait for the AP to respond with Clear to Send
(CTS). This helps prevent mid-air collisions for wireless clients that are
not within wireless peer range and cannot detect when other wireless
clients are transmitting.
2333 bytes
short-preamble
Enables or disables short preamble for 802.11b/g radios. Network
performance may be higher when short preamble is enabled. In mixed
radio environments, some 802.11b wireless client stations may
experience difficulty associating with the AP using short preamble. To use
only long preamble, disable short preamble. Legacy client devices that
use only long preamble generally can be updated to support short
preamble.
— enabled
ssid-enable
Enables/disables this SSID. — enabled
strict-svp
Enable Strict Spectralink Voice Protocol (SVP) — disabled
wepkey1 -
wepkey4
Static WEP key associated with the key index. Can be 10 or 26 hex
characters in length.
——
weptxkey
Key index that specifies which static WEP key is to be used. Can be 1, 2, 3,
or 4.
1, 2, 3, 4 1
wmm
Enables or disables WMM, also known as IEEE 802.11e Enhanced
Distribution Coordination Function (EDCF). WMM provides prioritization of
specific traffic relative to other traffic in the network.
— disabled
wmm-be-dscp
DSCP value used to map WMM best-effort traffic. 0-255 24
wmm-bk-dscp
DSCP used to map WMM background traffic. 0-255 8
Parameter Description Range Default