Users Guide

276 | Authentication Servers Dell Networking W-Series ArubaOS 6.4.x| User Guide
RADIUS Accounting on Multiple Servers
ArubaOS provides support for the controllers to send RADIUS accounting to multiple RADIUS servers. The
controller notifies all the RADIUS servers to track the status of authenticated users. Accounting messages are
sent to all the servers configured in the server group in a sequential order.
You can enable multiple server account functionality by using the WebUI and CLI:
Using the WebUI
1. Navigate to the Configuration > Security > Authentication > AAA Profiles page.
2. Select AAA Profile, then select the AAA profile instance.
3. Select Multiple Server Accounting checkbox.
4. Click Apply.
Using the CLI
To enable RADIUS Accounting on Multiple Servers functionality, use the following CLI:
(host) (config) # aaa profile <profile_name>
multiple-server-accounting
TACACS+ Accounting
TACACS+ accounting allows commands issued on the controller to be reported to TACACS+ servers. You can
specify which types of commands are reported (action, configuration, or show commands), or report all
commands.
You can only configure TACACS+ accounting through the CLI:
(host)(config) #aaa tacacs-accounting server-group <group> command
{action|all|configuration|show} mode {enable|disable}
Configuring Authentication Timers
Table 52 describes the timers you can configure for all clients and servers. These timers can be left at their
default values for most implementations.