Users Guide

Parameter Description
Default: sAMAccountName
Timeout Timeout period of a LDAP request, in seconds.
Default: 20 seconds
Mode Enables or disables the server.
Default: enabled
Preferred
Connection Type
Preferred type of connection between the controller and the LDAP server. The
default order of connection type is:
1. ldap-s
2. start-tls
3. clear-text
The controller first tries to contact the LDAP server using the preferred connection
type, and only attempts to use a lower-priority connection type if the first attempt is
not successful.
NOTE: If you select clear-text as the preferred connection type, you must also
enable the allow-cleartext option.
Using the WebUI
1. Navigate to the Configuration > Security > Authentication > Servers page.
2. Select LDAP Server to display the LDAP Server List.
3. To configure an LDAP server, enter the name for the server and click Add.
4. Select the name to configure server parameters. Enter parameters as described in Table 46. Select the
Mode checkbox to activate the authentication server.
5. Click Apply.
The configuration does not take effect until you perform this step.
Using the CLI
(host)(config) #aaa authentication-server ldap <name>
host <ipaddr>
(enter parameters as described in Table 46)
enable
Configuring a TACACS+ Server
Table 47 defines the TACACS+ server parameters.
Dell Networking W-Series ArubaOS 6.4.x | User Guide Authentication Servers | 261