Release Notes

6 | The ArubaOS Command-Line Interface Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Command Description
l arp
l grat-arp
ipv6 firewall The valid range for the following parameters is changed to <1-
16384>:
l ping
l session
l tcp-syn
rf arm-profile The default values for the following parameters are changed:
l cm-band-g-max-signal
l cm-sticky-snr
l cm-sticky-min-signal
l cm-lb-client-thresh
show airgroup status l The Chromecast service is renamed to DIAL.
l The googlecast service is introduced.
show airgroupservice l The Chromecast service is renamed to DIAL.
l The googlecast service is introduced.
show ap arm client-match
restriction-table
Following parameters are introduced:
l PS deauth
l Probe(home/scan/bc_ssid)
l Auth(home/scan)
l Radio Bssid
The following parameters are modified:
l Time last restricted
l Restricted(Cur/Last)
l Time since last restricted
show ap blacklist-clients The following reason codes are introduced:
l ARP-attack
l gratuitous-ARP-attack
show datapath The following parameters are introduced as part of the show
datapath frame command output:
l Excessive ARP Requests
l Excessive Gratuitous ARP Requests
The acl id <ACL-id> parameter has been added. This command
displays acl-id related information. The acl {[ap-name <ap-name>
| ip-addr <ip-address>] name <acl-name> type <acl-type>}
command retrieves ACL related details from an access point using
the access point's name or ip-address.
show firewall The following parameters are introduced as part of the show
firewall command output:
l Blacklist Grat ARP attack client
l Blacklist ARP attack client
l Monitor ARP attack
l Monitor Gratuitous ARP attack
show switches The regulatory parameter was added.
show whitelist-db cpsec The following new parameters are introduced:
l cert-type
l page