Release Notes

ip radius
ip radius {nas-ip <ipaddr>|rfc-3576-server udp-port <port>|source-interface {loopback|vlan
<vlan>}
Description
This command configures global parameters for configured RADIUS servers.
Syntax
Parameter Description Range Default
nas-ip
NAS IP address to send in RADIUS packets. A server-specific
NAS IP configured with the aaa authentication-server
radius command supersedes this configuration.
— —
rfc-3576-server
Configures the UDP port to receive requests from a RADIUS
server that can send user disconnect and change-of-
authorization messages, as described in RFC 3576, “Dynamic
Authorization Extensions to Remote Dial In User Service
(RADIUS)”. See the aaa rfc-3576-server command to
configure the server.
NOTE: This parameter can only be used on the master
controller.
— —
udp-port
UDP port to receive server requests. 0-
65535
3799
source-inter
face
Interface for all outgoing RADIUS packets. The IP address of
the specified interface is included in the IP header of RADIUS
packets. The interface can be one of the following:
— —
loopback
The loopback interface. — —
vlan
The specified VLAN. — —
Usage Guidelines
This command configures global RADIUS server parameters. If the aaa authentication-server radius
command configures a server-specific NAS IP, the server-specific IP address is used instead.
Example
The following command configures a global NAS IP address sent in RADIUS packets:
(host) (config) #ip radius nas-ip 192.168.1.245
Command History
This command was available in ArubaOS 3.0.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide ip radius | 474