Release Notes

Parameter Description Range Default
1
Minimum time of 1 µsec.
— —
2
Minimum time of 2 µsec.
— —
4
Minimum time of 4 µsec.
— —
8
Minimum time of 8 µsec.
— —
16
Minimum time of 16 µsec.
— —
mpdu-agg
Enables or disables MAC protocol data unit (MDPU)
aggregation.
High-throughput APs are able to send aggregated
MAC protocol data units (MDPUs), which allow an
AP to receive a single block acknowledgment
instead of multiple ACK signals. This option, which is
enabled by default, reduces network traffic
overhead by effectively eliminating the need to
initiate a new transfer for every MPDU.
— enabled
no
Negates any configured parameter. — —
short-guard-
intvl-20MHz
Enables or disables use of short guard interval in 20
MHz mode of operation.
—
enabled
short-guard-
intvl-40MHz
Enables or disables use of short guard interval in 40
MHz mode of operation.
—
enabled
short-guard-
intvl-80MHz
Enables or disables use of short guard interval in 80
MHz mode of operation.
—
enabled
stbc-rx-streams
Controls the maximum number of spatial streams
usable for STBC reception. 0 disables STBC
reception, 1 uses STBC for MCS 0-7. Higher MCS
values are not supported. (Supported on the W-
AP90 series, W-AP130 Series, W-AP68, W-AP175
and W-AP105 only. The configured value will be
adjusted based on AP capabilities.)
NOTE: If transmit beamforming is enabled, STBC
will be disabled for disabled for beamformed
frames.
0-1 1
stbc-tx-streams
Controls the maximum number of spatial streams
usable for STBC transmission. 0 disables STBC
transmission, 1 uses STBC for MCS 0-7. Higher MCS
values are not supported. (Supported on W-AP90
series, W-AP175, W-AP130 Series and W-AP105
only. The configured value will be adjusted based on
AP capabilities.)
NOTE: If transmit beamforming is enabled, STBC
will be disabled for disabled for beamformed
frames.
0-1 1
supported-mcs-
set
Comma-separated list of Modulation Coding
Scheme (MCS) values or ranges of values to be
supported on this high-throughput SSID.
0-23 0-23
temporal-diversity
Shows if temporal diversity has been enabled or dis-
abled. When this feature is enabled and the client is
— disabled
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide wlan ht-ssid-profile | 2064