Release Notes

1811 | show whitelist-db cpsec-status Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
show whitelist-db cpsec-status
show whitelist-db cpsec-status
Description
Display aggregate status information APs in the campus AP whitelist.
Syntax
No parameters.
Example
The output of the following command shows current status information for all APs in the campus AP whitelist:
(host) #show whitelist-db cpsec-status
Entries in Whitelist database
Total entries: 41
Approved entries: 0
Unapproved entries: 0
Certified entries: 40
Certified hold entries: 0
Revoked entries: 1
Marked for deletion entries: 0
The output of this command includes
Syntax
Parameter Description
Total entries
Total number of entries in the campus AP whitelist
Approved entries:
Number of APs that are valid, but is waiting to receive a certificate.
Unapproved entries
Number of APs that have certificate that was not not approved.
Certified entries
Number of APs that have an approved certificate.
Certified hold entries
Number of APs in the certified hold state. An AP is put in this state when
the controller thinks the AP a certified certificate yet the AP requests to
be certified again. Since this is not a normal condition, the AP will not be
reapproved as a secure AP until a network administrator manually
changes the status of the AP to verify that it is not compromised.
Revoked entries
Number of APs whose entries have been revoked
Marked for deletion entries
Number of APs whose entries have been marked for deletion. An entry
will not be permanently deleted until all other controllers on the network
acknowledge the deletion.