Release Notes

ap debug client-trace start
ap debug client-trace start
{ap-name <ap-name>}|{ip-addr <ip>}|{ip6-addr <ip6>} mac <client-mac>
[length-range <max>|[length-range <min>}
Description
Use this command to trace management packets from a client MAC address.
Syntax
Parameter Description
ap-name <ap-name>
Name of the AP.
ip-addr <ip-addr>
IPv4 address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
mac <client-mac> MAC address of the client..
length-range <max> data packet max length.
length-range <min> data packet min length.
Usage Guidelines
This command should only be used under the guidance of Dell technical support.
.
Related Commands
Command Description
ap debug client-trace
stop
Use this command to stop tracing management packets from a client MAC address.
Command History
Introduced in ArubaOS 6.3.
Command Information
Platforms Licensing Command Mode
W-6000M3 controllers Base operating system Enable mode on master or local
controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide ap debug client-trace start | 142