Release Notes

show interface vlan
show interface vlan
Description
Displays information about a specified VLAN interface.
Syntax
No parameters
Example
The example below shows the output of show interface vlan 1 on a W-650 controller.
#show interface vlan 1
VLAN1 is up line protocol is down
Hardware is CPU Interface, Interface address is 00:0B:86:61:82:40 (bia 00:0B:86:61:82:40)
Description: 802.1Q VLAN
Internet address is 10.3.49.50 255.255.255.0
Routing interface is enable, Forwarding mode is enable
Directed broadcast is disabled, BCMC Optimization disabled ProxyARP disabled Suppress ARP
disabled
Encapsulation 802, loopback not set
MTU 1500 bytes
Last clearing of "show interface" counters 4 day 0 hr 28 min 58 sec
link status last changed 4 day 0 hr 28 min 58 sec
Proxy Arp is disabled for the Interface
DHCP Option-82 mac and essid are configured on this Interface
The output of this command includes the following parameters:
Parameter Description
VLAN1 is...
Status of the specified VLAN
line protocol is...
Displays the status of the line protocol on the
specified port
Hardware is...
Describes the hardware interface type
Interface address is...
Displays the MAC address of the hardware interface
Description
Description of the specified VLAN
Internet address is...
IP address and subnet mask of the specified VLAN
Routing interface is...
Status of the routing interface
Forwarding mode is...
Status of the forwarding mode
Directed broadcast is...
Displays whether or not directed broadcast is
enabled
Encapsulation
Encapsulation type
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show interface vlan | 1384