Release Notes

show interface tunnel
show interface tunnel <id>
Description
Displays information about tunnel interfaces.
Syntax
Parameter Description
id
Tunnel interface number.
Example
The example below shows the output of show interface tunnel for IPv4.
#show interface tunnel 2000
Tunnel 2000 is up line protocol is up
Description: Tunnel Interface
Internet address is 3.3.3.1 255.255.255.0
Source 192.168.203.1
Destination 192.168.202.1
Tunnel mtu is set to 1100
Tunnel is an IP GRE TUNNEL
Tunnel is Trusted
Inter Tunnel Flooding is enabled
Tunnel keepalive is disabled
The example below shows the output of show interface tunnel for IPv6.
#show interface tunnel 21
Tunnel 21 is up line protocol is up
Description: Tunnel Interface
Internet address is 2005:81::1:2
Source 2082::802:1(Vlan 802)
Destination 2082::802:2
Tunnel mtu is set to 1280
Tunnel is an IPv6 GRE TUNNEL
Tunnel is Trusted
Inter Tunnel Flooding is enabled
Tunnel keepalive is disabled
The output of this command includes the following parameters:
Parameter Description
Tunnel 2000 is...
Status of the specified tunnel.
line protocol is...
Displays the status of the line protocol on the specified tunnel.
Description
Description of the specified interface.
Internet address is...
IP address of the specified interface.
Source
IP address of the tunnel’s source.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show interface tunnel | 1382