Release Notes

1023 | show ap details Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Column Description
Bootstrap threshold
Number of consecutive missed heartbeats on a GRE tunnel
(heartbeats are sent once per second on each tunnel) before an AP
rebootstraps. On the controller, the GRE tunnel timeout is 1.5 x
bootstrap-threshold; the tunnel is torn down after this number of
seconds of inactivity on the tunnel.
Slot/Port
The controller port used by the AP, in the format <slot>/<port>.
The <port> parameter refers to the network interfaces that are
embedded in the front panel of the W-3000 Series controller. Port
numbers start at 0, from the left-most position.
High throughput
Shows if high-throughput (802.11n) features are enabled or
disabled.
Mode
Shows the operating modes for the AP.
l AP: Device provides transparent, secure, high-speed data
communications between wireless network devices and the
wired LAN.
l AM: Device behaves as an air monitor to collect statistics,
monitor traffic, detect intrusions, enforce security policies,
balance traffic load, self-heal coverage gaps, etc.
Band
The RF band in which the AP should operate:
l 802.11g = 2.4 GHz
l 802.11a = 5 GHz
Channel
Channel number for the AP 802.11a/802.11n physical layer. The
available channels depend on the regulatory domain (country).
Secondary Channel
The secondary channel number for the AP. The secondary channel
is a 20 MHz channel used in conjunction with the primary channel to
create a 40 MHz channel for high-throughput clients.
High-throughput capable APs use only the primary channel to
communicate with 20 MHz clients. The secondary channel is used
for transmissions with 40 MHz capable high-throughput clients.
EIRP
Current effective Isotropic Radiated Power (EIRP).
AP Name
Name of the AP.
AP Group
AP group to which the AP belongs.
Location name
Fully-qualified location name (FQLN) for the AP.
SNMP sysLocation
User-defined description of the location of the AP, as defined with
the command provision-ap syslocation.
Master
Name or IP address for the master controller.
Gateway
IP address of the default gateway for the AP.
Netmask
Netmask for the AP’s IP address.
IP Addr
IP address for the AP.
Dns IP
IP address of the DNS server.
Domain Name
Domain name used by the AP.