Reference Guide

288 | interface range Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Usage Guidelines
Use the show port status command to obtain information about the interfaces available on the controller.
Example
The following command configures a range of interface as a trunk port for a set of VLANs:
mode Sets the mode of the interface to access or trunk mode only. — —
trunk Sets the interface as a trunk port for the specified VLANs. A
trunk port carries traffic for multiple VLANs using 802.1q tagging
to mark frames for specific VLANs. You can include all VLANs
configured on the controller, or add or remove specified VLANs.
Specify native to identify the native VLAN for the trunk mode
interface. Frames on the native VLAN are not 802.1q tagged.
——
trusted Set this interface and range of VLANs to be trusted. VLANs not
included in the trusted range of VLANs are, by default, untrusted.
Trusted ports and VLANs are typically connected to internal
controlled networks, while untrusted ports connect to third-party
APs, public areas, or other networks to which access controls
should be applied. When Dell APs are attached directly to the
controller, set the port to be trusted.
— enabled
vlan <word> Sets the supplied range of VLANs as trusted. All remaining
become untrusted automatically.
For example, If you set a VLAN range as:
vlan 1-10, 100-300, 301, 305-400, 501-4094
Then all VLANs in this range are trusted and all others become
untrusted by default. You can also use the no trusted vlan
command to explicitly make an individual VLAN untrusted. The
no trusted vlan command is additive and adds given vlans to the
existing untrusted vlan set.
However, if you execute the trusted vlan <word> command, it
overrides any earlier untrusted VLANs or a range of untrusted
VLANs and creates a new set of trusted VLANs.
NOTE: A port supports a user VLAN range from 1-4094. If you
want to set all VLANs (1-4094) on a port as untrusted then mark
the port itself as untrusted. By default the port and all its
associated VLANs are trusted.
1-4094 —
Parameter Description Range Default