Users Guide

686 | Link Layer Discovery Protocol Dell Networking W-Series ArubaOS 6.4.x| User Guide
l System name TLV
l VLANname TLV
Default LLDP Configuration
To display the default LLDP information, use the following command:
(host) #show lldp interface gigabitethernet 1/1
Interface: FE1/1
LLDP Tx: Disabled, LLDP Rx: Disabled
Proprietary Neighbor Discovery: Disabled
LLDP-MED: Disabled
Fast Transmit interval: 1, Fast Transmit message counter: 4
Transmit interval: 30, Transmit hold 4, Hold timer: 120
When you use the default LLDP configuration, the RX and TX parameters are disabled. You must explicitly enable
them for LLDP to work.
Configuring LLDP
You can configure LLDP using the CLI. For detailed information on the LLDP commands, refer to interface
fastethernet | gigabitethernet in the ArubaOS Command-Line Interface Reference Guide.
(host)(config) #interface gigabitethernet <slot/port>
(host)(config-if) #lldp
fast-transmit-counter <1-8>
fast-transmit-interval <1-3600>
med
receive
transmit
transmit-hold <1-100>
transmit-interval <1-3600>
The med command is not currently supported but will be supported in a future release. The fast-transmit-interval
<1-3600> and the fast-transmit-counter <1-8> parameters should also be used with the med command.
Monitoring LLDP Configuration
This section describes commands for monitoring LLDP configurations.
Display LLDP Interface
To display all LLDP information for all interfaces, use the following command:
(host)# show lldp interface
LLDP Interfaces Information
---------------------------
Interface LLDP TX LLDP RX LLDP-MED TX interval Hold Timer
--------- ------- ------- -------- ----------- ----------
GE1/3 Enabled Enabled Enabled 30 120
GE1/4 Enabled Enabled Enabled 30 120
Display LLDP Interface <interface>
To display LLDP information for a specific interface, use the following command:
(host) #show lldp interface gigabitethernet <slot/port>
(host) #show lldp interface gigabitethernet <1/3>
Interface: gigabitethernet0/0/1