Owners Manual

Steps

1. Align the ports on the system board with the slots on the chassis and align the system board in place.

2. Replace the single (M2x4) screw that secures the system board to the chassis.

3. Replace the eight (6-32) screws that secure the system board to the chassis.

4. Route and connect all the cables that you disconnected from the system board .

5. Align the screw holes on the ports bezel with the screw holes on the chassis.

6. Replace the single (6-32) screw that secures the ports bezel to the chassis.

Next steps

1. Install the processor.

2. Install the processor fan and heat-sink assembly.

3. Install the memory module.

4. Install the wireless card.

5. Install the solid-state drive/Intel Optane memory module.

6. Install the right-side cover.

7. Follow the procedure in After working inside your computer.

Disassembly and reassembly