Users Guide

Setting Up the Monitor | 31

Setting Up the Monitor

Attaching the Stand

NOTE: The stand is detached when the monitor is shipped from the factory.

NOTE: This is applicable for a monitor with a stand. When any other stand is

bought, please refer to the respective stand setup guide for the set up instructions.

To attach the monitor stand:

1. Remove the cover and place the monitor on it.

2. Attach the stand riser to the stand base, and tighten the thumbscrew below the

stand base.

3. Fit the two tabs on the upper part of the stand to the groove on the back of the

monito

4. Press the stand till it snaps into place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the

Safety Instructions

NOTE: Do not connect all cables to the computer at the same time.

To connect your monitor to the computer:

1. Turn Off your computer and disconnect th

e power cable.

Connect the VGA/HDMI/MHL/DP cable from your monitor to the computer.