User guide

Redundancy 102
Composite Device in Power Source View
When a redundancy and shutdown module is activated, a composite device can be selected as power
source. The user can show it in the Power Source view.
In this case, Information, Status, Events, and Power Components panels are displayed with specific data
(see Figure 85).
Figure 85. Composite Device Power Source View
Power Components Sub-view
When redundancy and shutdown modules are activated, a new power component view is available as a
sub-view of the Power Source view. This view shows a list of nodes with their properties (see Figure 86).
NOTE:
This view shows only components of the selected power source if it is a composite device.
0119_2-Dell MUMC UG.book Page 102 Saturday, November 2, 2013 4:59 PM