Users Guide

Supervision 67
The following node information is displayed in this panel:
• Description: Commercial product name
•
Firmware version: Firmware revision level of the UPS or the Dell NMC card set up as power source
•
Nominal Apparent Power: UPS Nominal Apparent Power (in Watt)
•
Serial Number: Device Serial Number (if available)
•
Battery state: Charging / Discharging / Default / Floating / Resting
•
Power source: AC Power / Battery
•
Load Level: Output load level of the device
•
Battery capacity: Battery capacity of the device
•
Battery run time: Thee device remaining backup time
•
Load segment 1: Output outlet status (ON/OFF)
•
Load segment 2: Output outlet status (ON/OFF)
NOTE: The information displayed in this panel depends on the UPS capabilities (see Figure 51).
Measures Panel
This panel displays the selected device electrical parameters for single-phase or three-phase devices,
depending on the node capabilities (see Figure 51).
Figure 51. Measures Panel
The following node information is displayed in this panel:
• xxx.xxx.xxx.xxx: The DNS name (or IP address) is displayed near the "status icon"
• Description: The commercial product name
• Nominal Apparent Power: The UPS Nominal Apparent Power (in VA or KVA)
0120_3-Dell ULNM UG.book Page 67 Saturday, November 2, 2013 5:34 PM