Users Guide

32 | Setting Up the Monitor
NOTE: UP3017A default setting is DP 1.2. A DP 1.1 Graphic card may not display
normally. Please refer to “product specific problems – No image when using DP
connection to the PC” to change default setting.
Single monitor connection
Connecting the DP (or mDP) cable
DP
mDP
NOTE: Default is DP port. Select input source on monitor to switch to mDP.
Connecting the HDMI cable (Optional)
HDMI
HDMI
Connecting the USB cable
After you have completed connecting the DP-mDP cables, follow the procedure below
to connect the USB 3.0 cable to the computer and complete your monitor setup:
1 a. Connect one computer:
Connect the upstream USB 3.0 port (cable supplied) to an appropriate USB 3.0 port
on your computer.
b. Connect two computers:
Connect the upstream USB 3.0 ports to appropriate USB 3.0 ports on the two
computers. Then use the OSD menu to select between the two USB upstream
sources and input sources. See USB Select Switch.