User Manual

34  │  Setting Up the Monitor
Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section,
fol low the Safety Instructions.
NOTE: Do not connect all cables to the computer at the same time.
To connect your monitor to the
computer:
1. T
urn Off your computer and disconnect the power cable.
2. Connec
t the HDMI/DP/USB Type-C cable from the monitor to your computer
or USB Type-C device.
Connecting the HDMI cable
NOTE: The default out of factory setting in the U4919DW is HDMI 2.0.
If the monitor fails to show any content after the HDMI cable is
connected, follow the procedures below to change the settings from
HDMI 2.0 to HDMI 1.4:
• Press second button next to the button to activate the OSD menu.
• Use the and buttons to highlight Input Source, then use the
button enter the submenu.
• Use the and buttons to highlight HDMI.
• Press and hold the button for approximately 10 seconds, and the
HDMI configuration message appears.