Owner's Manual

Table Of Contents

5. Disassembly and Assembly Procedures

S13

Take 1pcs USB board, 2pcs cables and 1pcs

conductive foam. Connect the 2pcs cables to the

connectors of the Usb board, then turn over the

board and paste the conductive foam on the back of

the USB board, and then locate the USB board into

the correct position of the middle bezel. Use a

Philips-head screwdriver to tighten 1pcs screw for

locking the USB unit with the middle bezel, then

connect the two USB cables to the connectors of

interface board.

(No.1 screw size=M3x6, Torque=4±0.5kgfxcm)

S14

Move the assembled rear cover close to the panel

unit, then connect the joystick key cable to the

connector of interface board. Put down the rear

cover and push the rear cover on the positions

marked as the picture below shown for

mechanisms engagement.

S16

Take 1pcs joystick key and 1pcs OSD board,

assemble the joystick key with the OSD board.

Locate the board to the correct position of the rear

cover, then use a Philips-head screwdriver to tighten

2pcs screws for locking the board with rear cover.

Tear off the tape papers on the back of the cable,

and then fix the key cable with tapes.

(No.1~2 screw size=M2x2.4, Torque=0.9±0.1kgfxcm)

S15

Paste 1pcs aluminum foil to fix the bracket on the

specific position as the picture below shown.