Users Guide
Table Of Contents
- Safety Instructions
- About Your Monitor
- Setting Up the Monitor
- Connecting the Stand
- Using the Tilt, Swivel, and Vertical Extension
- Rotating the Display
- Configuring the Display Settings on Your Computer after Rotation
- Organizing Your Cables
- Connecting Your Monitor
- Dell Power Button Sync (DPBS) (U2722DE Only)
- Securing Your Monitor Using Kensington Lock (Optional)
- Removing the Monitor Stand
- Wall Mounting (Optional)
- Operating the Monitor
- Troubleshooting
- Appendix
36 | Setting Up the Monitor
Setting Up the Monitor
Connecting the Stand
NOTE: The stand riser and stand base are detached when the monitor is
shipped from the factory.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are connecting a stand that you
purchased from any other source, follow the set up instructions that were
included with the stand.
To attach the monitor stand:
1. Open the front ap of the box to get the stand riser and stand base.
2. Align and place the stand riser on the stand base.
3. Open the screw handle at the bottom of the stand base and turn it clockwise to
secure the stand assembly.