Owner`s manual
Table Of Contents
- Contents
- Notes, Cautions, and Warnings
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit (PSU)
- Removing the Cover
- Installing the Cover
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Thermal Sensor
- Installing the Thermal Sensor
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Air Tunnel
- Installing the Air Tunnel
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heat Sink
- Installing the Heat Sink
- Removing Heat Sink Fan
- Installing the Heat-Sink Fan
- Removing the Processor
- Installing the Processor
- Removing the System Fan
- Installing the System Fan
- Removing the PSU Card
- Installing the PSU Card
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the Front Input/Output (I/O) Panel
- Installing the Front Input/Output (I/O) Panel
- Removing the Speaker
- Installing the Speaker
- Removing the System Board
- Installing the System Board
- System Board Components
- Additional Information
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Technical Specifications
- Contacting Dell
Table 3. System Configuration
Option Description
Integrated NIC Allows you to configure the integrated
network controller. The options are:
• Disabled
• Enabled (Default Setting)
USB Controller Allows you to control the USB controller. The
options are:
• Enable USB Controller (Default
Setting)
• Disable USB Mass Storage Dev
• Disable USB Controller
Serial Port Identifies and defines the serial port settings.
You can set the serial port to:
• Disabled
• Auto
• COM1 (Default Setting)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate
resources even if the setting is disabled.
SATA Operation Allows you to configure the internal SATA
hard-drive controller. The options are:
• Disabled
• ATA
• AHCI (Default Setting)
NOTE: SATA is configured to support RAID
mode.
USB Configuration Allows you to define the USB configuration.
The options are:
• Enable Boot Support/Front USB Ports/
Rear USB Ports/USB3 Ports
SMART Reporting This field controls if the hard drive errors for
the integrated drives are reported during
system startup. This technology is part of the
SMART (Self Monitoring Analysis and
Reporting Technology) specification.
• Enable SMART Reporting - This option
is disabled by default.
41