Reference Guide

Table Of Contents
Troubleshooting 291
is missing an essential file. To remove and then reinstall the program:
Windows Vista
1
Click
Start
Control Panel
Programs
Programs and Features
.
2
Select the program you want to remove.
3
Click
Uninstall
.
4
See the program documentation for installation instructions.
Windows XP
1
Click
Start
Control Panel
Add or Remove Programs
Programs and Features
.
2
Select the program you want to remove.
3
Click
Uninstall
.
4
See the program documentation for installation instructions.
drive letter :\ IS NOT ACCESSIBLE. THE DEVICE IS NOT READY The drive
cannot read the disk. Insert a disk into the drive and try again.
I
NSERT BOOTABLE MEDIA Insert a bootable CD or DVD.
N
OT ENOUGH MEMORY OR RESOURCES. CLOSE SOME PROGRAMS AND TRY
AGAIN Close all windows and open the program that you want to use. In some
cases, you may have to restart your computer to restore computer resources. If so, run
the program that you want to use first.
O
PERATING SYSTEM NOT FOUND Contact Dell (see"Contacting Dell" on
page 337).
IEEE 1394 Device Problems
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTE: Your computer supports only IEEE 1394a standard.
E
NSURE THAT THE CABLE FOR THE IEEE 1394 DEVICE IS PROPERLY INSERTED INTO
THE DEVICE AND INTO THE CONNECTOR ON THE COMPUTER
ENSURE THAT THE IEEE 1394 DEVICE IS ENABLED IN SYSTEM SETUP See
"Working With Options on the System Setup Program Screen" on page 308.
E
NSURE THAT THE IEEE 1394 DEVICE IS RECOGNIZED BY WINDOWS
Windows Vista
1
Click
Start
Control Panel
Hardware and Sound
.
2
Click
Device Manager.