Users Guide

Usage
Information
FTP, TFTP, MAC ACLs, and SNMP operations are not supported. IP ACLs are supported on VLANs only.
The no version of this command deletes the interface.
NOTE: In SmartFabric Services mode, creation of VLAN is disabled.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)#
Supported
Releases
10.2.0E or later
link-bundle-utilization
Configures link-bundle utilization.
Syntax
link-bundle-utilization trigger-threshold value
Parameters value — Enter the percentage of port-channel bandwidth that triggers traffic monitoring on port-
channel members, from 0 to 100.
Default Disabled
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# link-bundle-utilization trigger-threshold 10
Supported
Releases
10.2.0E or later
mode
Configures a front-panel unified port group to operate in Fibre Channel or Ethernet mode, or a QSFP28-DD or QSFP28 port
group to operate in Ethernet mode, with the specified speed on activated interfaces.
Syntax
mode {Eth {100g-2x | 100g-1x | 50g-2x | 40g-2x | 40g-1x | 25g-8x [fabric-
expander-mode] | 25g-4x | 10g-8x | 10g-4x} | FC {32g-4x | 32g-2x | 32g-1x |
16g-4x}}
Parameters
● mode Eth — Configure a port group in Ethernet mode and set the speed to:
○ 100g-2x — Split a QSFP28-DD port into two 100GE interfaces.
○ 100g-1x — Reset a QSFP28 port group to 100GE mode.
○ 50g-2x — Split a QSFP28 port into two 50GE interfaces.
○ 40g-2x — Split a port group into two 40GE interfaces.
○ 40g-1x — Set a port group to 40G mode for use with a QSFP+ 40GE transceiver.
○ 25g-8x fabric-expander-mode — Split a QSFP28-DD port into eight 25GE interfaces for
connection to a Fabric Expander.
○ 25g-8x — Split a port group into eight 25GE interfaces.
○ 25g-4x — Split a port group into four 25GE interfaces.
○ 10g-8x — Split a port group into eight 10GE interfaces.
○ 10g-4x — Split a port group into four 10GE interfaces.
● mode FC — Configure a port group in Fibre Channel mode and set the speed to:
○ 32g-4x — Split a port group into four 32GFC interfaces.
○ 32g-2x — Split a port group into two 32GFC interfaces, subports 1 and 3.
○ 32g-1x — Split a port group into one 32GFC interface, subport 1.
○ 16g-4x — Split a port group into four 16GFC interfaces; supports 4x32GFC oversubscription.
Default S4148U-ON: Depends on the port profile activated.
Interfaces 289