Users Guide

● tcp — (Optional) Enter the TCP address to deny.
● udp — (Optional) Enter the UDP address to deny.
● A::B — Enter the IPv6 address in dotted decimal format.
● A::B/x — Enter the number of bits to match to the IPv6 address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
● host ipv6-address — (Optional) Enter the keyword and the IPv6 address to use a host address
only.
● capture — (Optional) Capture packets the filter processes.
● count — (Optional) Count packets the filter processes.
● byte — (Optional) Count bytes the filter processes.
● dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
● fragment — (Optional) Use ACLs to control packet fragments.
● log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny ipv6 any any capture session 1
Supported
Releases
10.2.0E or later
deny (MAC)
Configures a filter to drop packets with a specific MAC address.
Syntax
deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn
[00:00:00:00:00:00] | any} [protocol-number | capture | cos | count | vlan]
Parameters
● nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets are
sent.
● 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
● any — (Optional) Set routes which are subject to the filter.
○ protocol-number — (Optional) MAC protocol number identified in the header, from 600 to
ffff.
○ capture — (Optional) Capture packets the filter processes.
○ cos — (Optional) CoS value, from 0 to 7.
○ count — (Optional) Count packets the filter processes.
○ vlan — (Optional) VLAN number, from 1 to 4093.
Default Disabled
Command Mode MAC-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# deny any any cos 7
OS10(conf-mac-acl)# deny any any vlan 2
Supported
Releases
10.2.0E or later
Access Control Lists 1123