Users Guide

Table Of Contents

Setting up the monitor | 23

Setting up the monitor

Connecting the stand

NOTE: The stand riser and stand base are detached when the monitor is

shipped from the factory.

NOTE: The following instructions are applicable only for the stand that

was shipped with your monitor. If you are connecting a stand that you

purchased from any other source, follow the set up instructions that were

included with the stand.

CAUTION: Place monitor of a flat, clean, and soft surface to avoid

scratching the display panel.

To attach the monitor stand:

1. Align the tabs on the stand base with the slots on the stand riser.

2. Insert the stand riser on the stand base firmly.

3. Open the screw handle at the bottom of the stand base, and rotate it clockwise

to tighten the screw firmly. Then close the screw handle.