User's Manual

Using the Serial and racadm Commands 165
If you type a command that is not supported on the system you are using, an
error similar to the following is displayed.
setsvctag: Firmware: UNSUPPORTED COMMAND
Table 8-1 lists the serial/telnet commands. These commands are also supported
as racadm commands. The descriptions and "man page" information including
required syntax for the serial/telnet commands are identical for the racadm
command. You do not need to type racadm before typing a serial/telnet
command because the serial/telnet commands are not racadm commands.
They are at the same "level." For detailed information about the required syntax
for each racadm command see "racadm Subcommand Man Pages."
Table 8-1. Serial/Telnet Commands
Command Description
help Lists DRAC 4 commands.
help
<subcommand>
Lists the usage statement for the specified subcommand.
logout Logs out of a DRAC 4 session and then prints a new login
prompt.
quit Logs out of a DRAC 4 session and then prints a new login
prompt.
exit Logs out of a DRAC 4 session and then prints a new login
prompt.
getsysinfo Displays general DRAC 4 and system information.
serveraction Executes a graceful hard server reset, or power-on, power-off, or
power-cycle.
getraclog Displays DRAC 4 log entries.
clrraclog Clears the DRAC 4 log entries.
gettracelog Displays Trace Log entries.
getsel Displays System Event Log entries.
clrsel Clears the System Event Log entries.
connect com1 or
connect com2
Connects the DRAC 4 to the system serial port.
racadm Command line status and configuration utility for the DRAC 4.