User Guide

Installing System Components 109

Figure 3-18. Preparing the Tape Backup Unit and Tray (3.5-in HDD Chassis Only)

Install the slide rails or tray on the tape backup unit. Figure 3-18 shows the

3.5-inch tray installation.

Align the tape backup unit with the flex bay and slide the unit in until the

locking mechanism engages. See Figure 3-19.

If you are installing a SCSI tape backup unit, install the SCSI controller

expansion card in one of the expansion-card slots. See "Installing an

Expansion Card."

Connect the power cable to the power connector on the back of the tape

backup unit.

1 drive blank 2 screws (4)

3 tray 4 tape backup unit