Installation Manual

Configuring Security Features 363
The following example prevents more than three failed attempts within one
minute, and prevents additional login attempts for an hour.
racadm config -g cfgRacTuning -o
cfgRacTuneIpBlkEnable 1
racadm config -g cfgRacTuning -o
cfgRacTuneIpBlkFailCount 3
racadm config -g cfgRacTuning -o
cfgRacTuneIpBlkFailWindows 60
racadm config -g cfgRacTuning -o
cfgRacTuneIpBlkPenaltyTime 3600
Configuring the Network Security Settings Using the iDRAC6 GUI
NOTE: You must have Configure iDRAC6 permission to perform the following steps.
1 In the System tree, click iDRAC Settings .
2 Click the Network/Security tab and then click Network .
3 In the Network Configuration page, click Advanced Settings .
4 In the Network Security page, configure the attribute values and then click
Apply Changes .
Table 22-13 describes the
Network Security page settings.
5 Click the appropriate Network Security page button to continue. For more
information on the
Network Security page buttons, see the iDRAC6
Online Help
.
Table 22-13. Network Security Page Settings
Settings Description
IP Range Enabled Enables the IP Range checking feature, which defines a specific
range of IP addresses that can access the iDRAC6.