CLI Guide

Change SSD Cache Application Type
Description
This command changes the application type associated with the SSD cache. The application type can be
web server, database, or multimedia. Changing the application type changes the block size, sub block
size, populate on read threshold, and populate on write threshold for the virtual disks underlying the SSD
cache.
Syntax
set ssdCache [ssdCacheName] usageHint=(webServer|dataBase|fileSystem)
Parameters
Parameter Description
ssdCache
The alphanumeric identifier (including - and _) of
the SSD cache for which you want to change the
application type. Enclose the identifier in square
brackets ([ ]). If the SSD cache name contains
special characters or consists only of numbers, you
also must enclose the identifier in double
quotation marks (" ") inside square brackets.
usageHint
The values are based on the typical I/O usage
pattern of the application that is using the SSD
cache. Valid values are webServer, dataBase, or
fileSystem.
Check Remote Replication Status
NOTE: This command valid only with Fibre Channel storage arrays.
Description
This command returns the status of a remote replication virtual disk. Use this command to determine
when the status of the remote replication virtual disk becomes Optimal.
Syntax
check remoteReplication localVirtualDisk [virtualDiskName]
optimalStatus timeout=timeoutValue
Parameters
Parameter Description
localVirtualDisk
The name of any remote replication virtual disk.
The remote replication virtual disk can be the
147