CLI Guide
Resume SSD Cache
Description
This command restarts the caching for all virtual disks using the SSD cache that was temporarily stopped
with the suspend ssdCache command.
Syntax
resume ssdCache [ssdCacheName]
Parameter
Parameter Description
ssdCache
The alphanumeric identifier (including - and _) of
the SSD cache that you want to resume. Enclose
the identifier in square brackets ([ ]). If the SSD
cache name contains special characters or consists
only of numbers, you also must enclose the
identifier in double quotation marks (" ") inside
square brackets.
Revive Disk Group
Description
This command forces the specified disk group and associated failed physical disks to the Optimal state.
All physical disks assigned to the disk group must be installed before you attempt to run this command.
CAUTION: Correct use of this command depends on the data configuration on all of the physical
disks in the disk group. Never attempt to revive a physical disk unless supervised by a Customer
or Technical Support representative.
Syntax
revive diskGroup [diskGroupNumber]
Parameter
Parameter Description
diskGroup
Number of the disk group to be set to the optimal
state. You must put brackets ([ ]) around the disk
group number.
273