CLI Guide

Parameter Description
copyPriority
Specifies the priority that a virtual disk copy has
relative to host I/O activity. Valid entries are
highest, high, medium, low, or lowest.
NOTE: CopyPriority defines the amount of
system resources used to copy the data
between the source virtual disk and target
virtual disk of a virtual disk-copy pair. If you
select the highest priority level, the virtual disk
copy uses the most system resources to
perform virtual disk copy, which decreases
performance for host data transfers.
targetReadOnlyEnabled
Specifies whether the target virtual disk is write
enabled or read only. To be able to write to the
target virtual disk, set this parameter to FALSE. To
prevent writing to the target virtual disk, set this
parameter to TRUE.
copyType
Creates a virtual disk copy with or a snapshot
(legacy). Creating a virtual disk copy with a
snapshot (legacy) enables you to continue to write
to the source virtual disk while creating the virtual
disk copy. To create a virtual disk copy with a
snapshot (legacy), set this parameter to online. To
create a virtual disk copy without a snapshot
(legacy), set this parameter to offline.
If this parameter is not used, the virtual disk copy is
created without a snapshot (legacy).
Deactivate Remote Replication (Legacy)
NOTE: This command valid only with Fibre Channel storage arrays.
Description
This command deactivates the Remote Replication (legacy) premium feature, disassembles the
replication repository virtual disk, and releases the RAID controller module owner of the secondary virtual
disk. The RAID controller module host port that is dedicated to the secondary virtual disk is available for
host data transfers.
Syntax
deactivate storageArray feature=remoteReplication
Parameters
None.
208