CLI Guide

Parameters
Parameter Description
userLabel
The alphanumeric identifier (including - and _) that
you want to name the new SSD cache. Enclose the
identifier in double quotation marks (" ").
You can use any combination of alphanumeric
characters, underscore (_), hyphen (-), and pound
(#) for the identifier. Identifiers can have a
maximum of 30 characters.
physicalDisks
The physical disks that you want to use to create
the SSD cache. For dense expansion enclosures,
specify the enclosure ID value, the drawer ID value,
and the slot ID value for each physical disk that you
want to assign to the SSD cache. For non-dense
expansion enclosures, specify the enclosure ID
value and the slot ID value for each physical disk
that you assign to the SSD cache. Enclosure ID
values are 0 to 99. Drawer ID values are 0 to 4. Slot
ID values are 0 to 31. Enclose the enclosure ID
values, the drawer ID values, and the slot ID values
in parentheses.
updateExistingVirtualDisks
This optional parameter specifies whether the SSD
cache should be enabled for all existing virtual
disks in the storage array. To enable the SSD cache
for all existing virtual disks, set this parameter to
TRUE. If you want to enable the SSD cache for
individual virtual disks later, set this parameter to
FALSE. The default value is TRUE.
The type of secure drives to use in the disk group. These settings are valid:
• fips — To use FIPS compliant drives only.
• sed — To use SED compliant drives only.
NOTE: At this time, the controller firmware does not support mixed FIPS and SED drives within disk
groups and disk pools.
CAUTION: Use this parameter along with the securityType parameter. If you specify none for
the
securityType parameter, the value of the securePhysicalDisks parameter is ignored
because non-secure disk groups do not need to have secure drive types specified.
Notes
A storage array can have only one SSD cache.
204