Users Guide

1. configuration switch
Figure 2. Setting the PowerVault MD1200 Storage Enclosure Configuration Switch
1. configuration switch
Connecting The Storage Enclosure To The PowerVault DL2 x 00 System
Connect the SAS data cable from the PowerEdge RAID Controller (PERC) installed in the PowerVault DL2 x 00 system to
the primary Enclosure Management Module (EMM) SAS In port of the storage enclosure. For more information, see the
figures below.
NOTE: Do not connect tape devices to the PERC adapter. For more information about the proper configuration, see
figure Connecting the PowerVault DL2 x 00 System to the Storage Enclosure and Optional Tape Library.
Figure 3. Connecting the SAS Cable From the PowerVault DL2 x 00 System to the PowerVault MD1000 Storage Enclosure
11