Storage System Hardware Owner's Manual
Table Of Contents
- Hardware Owner’s Manual
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Bezel
- Opening and Closing the System
- Hard Drives
- Replacing a Hard-Drive Carrier
- Power Supplies
- System Fans
- Cooling Shroud
- Fan Brackets
- Cable Routing
- SAS Controller Daughter Card
- Configuring the Boot Device
- Expansion Cards
- Expansion-Card Cage
- DRAC Card and Cables
- Optical Drive and Cable
- System Memory
- Activating the Integrated NIC TOE
- Processors
- System Battery
- Expansion-Card Riser Boards
- Sideplane Board
- SAS Backplane Board
- Control Panel Assembly (Service-only Procedure)
- System Board (Service-only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Basic I/O Functions
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS Controller Daughter Card
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
![](/manual/dell/powervault-dl2000/storage-system-hardware-owners-manual/images/img-73.png)
74 Installing System Components
2 Viewing the assembly as shown in
Figure 3-6, a
lign the bottom rear screw
hole on the hard drive with the hole labeled "SATAu" on the hard drive
carrier.
When aligned correctly, the rear of the interposer will be flush with the
rear of the hard-drive carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
See
Figure 3-6.
4
Attach the interposer card to the rear of the SATA hard drive:
a
Angle the top of the interposer card into the inside top carrier rail so
that the tabs on the interposer card bracket attach to the slots on the
inside of the carrier rail.
See
Figure 3-6.
b
Rotate the bottom end of the card toward the hard drive to seat the
connector.
See
Figure 3-6.
c
Push the bottom end of the card to the hard drive until the latch on
the card bracket clicks into place.
Book.book Page 74 Monday, September 14, 2009 12:57 PM