Storage System Hardware Owner's Manual
Table Of Contents
- Hardware Owner’s Manual
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Bezel
- Opening and Closing the System
- Hard Drives
- Replacing a Hard-Drive Carrier
- Power Supplies
- System Fans
- Cooling Shroud
- Fan Brackets
- Cable Routing
- SAS Controller Daughter Card
- Configuring the Boot Device
- Expansion Cards
- Expansion-Card Cage
- DRAC Card and Cables
- Optical Drive and Cable
- System Memory
- Activating the Integrated NIC TOE
- Processors
- System Battery
- Expansion-Card Riser Boards
- Sideplane Board
- SAS Backplane Board
- Control Panel Assembly (Service-only Procedure)
- System Board (Service-only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Basic I/O Functions
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS Controller Daughter Card
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
![](/manual/dell/powervault-dl2000/storage-system-hardware-owners-manual/images/img-39.png)
40 About Your System
Read fault
Requested sector
not found
The operating system
cannot read from the
diskette or hard drive, the
system could not find a
particular sector on the
disk, or the requested
sector is defective.
Replace the diskette. Ensure
that the diskette and hard
drive cables are properly
connected. See
"Troubleshooting a USB
Device" on page 134, or
"Troubleshooting a Hard
Drive" on page 146 for the
appropriate drive(s)
installed in your system.
Remote
configuration
update attempt
failed
System unable to process
Remote Configuration
request
Retry Remote
Configuration.
ROM bad checksum =
address
Expansion card improperly
installed or faulty.
Reseat the expansion
card(s). Ensure that all
appropriate cables are
securely connected to the
expansion card(s). If the
problem persists, see
"Troubleshooting Expansion
Cards" on page 149.
Sector not found
Seek error
Seek operation
failed
Faulty diskette or hard
drive.
See "Troubleshooting an
Optical Drive" on page 143,
"Troubleshooting a USB
Device" on page 134, or
"Troubleshooting a Hard
Drive" on page 146 for the
appropriate drive(s)
installed in your system.
Shutdown failure Shutdown test failure. See "Troubleshooting
System Memory" on
page 142.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
Book.book Page 40 Monday, September 14, 2009 12:57 PM