White Papers
Table Of Contents
- Configuring the Dell™ PowerVault™ MD3000i Array as a Backup Target
- A Dell Technical White Paper
- by
- Dell Engineering
- Revision 1.0
- Executive Summary
- Introduction
- Prerequisites
- Technical Resources
- Configuration and Settings
- Installing the Dell PowerVault MD3000i Storage Software on the DL Backup to Disk Appliance
- Figure 2: MD3000i Resource CD menu
- Exposing the PowerVault™ MD3000i virtual disks to the DL Backup to Disk Appliance
- Configuring the PowerVault™ DL Backup to Disk Appliance Array Access
- Figure 4: MD3000i iSCSI Initiator Target portals
- Figure 6: CHAP logon information
- Conclusions
Configuring the Dell™ PowerVault™ MD3000i Array as a Backup Target for CommVault™ Simpana™
Page 7
Figure 3: iSCSI Initiator Name
6. For the Specify Host Group step, choose, NO: This Host will NOT share access to the same
virtual disks with other hosts
7. Click Finish to complete the Host setup.
8. Click on the Configure tab and select Create Host-to-Virtual Disk Mappings.
9. Select the newly created Host from the list of available hosts and click Next
10. Select all Virtual Disk(s) to be mapped to the DL Backup to Disk Appliance Host and click
Finish.