Users Guide

○ [1:0] 01h–Disabled
○ 01h–Enable local
● Response data byte 1—00h-success
○ CCh=invalid data field
○ FFh=unspecified error
● Response data byte 1—Cmd
○ [7:2] Reserved
○ [1:0] 00h–system log
● Response data byte 2—Status
○ [7:2] Reserved
○
[1:0] 01h–Disabled
○ 01h–Enable local
● Response data byte 3-70 for REMOTE (68 bytes) or 3-7 for LOCAL (5 bytes)—ENABLED REMOTE
○
NOTE: These request data bytes are required only when you enable either the local or remote system log.
64bytes : Hostname (ASCII)
Remote syslog server
4bytes : port number
To set the remote server ip address to 10.0.124.22 and port to 770:
ipmitool -I lanplus -H xx.xx.xx.xx -U xxx -P xxx raw 0x32 0x68 0x00
0x02 0x31 0x30 0x2e 0x30 0x2e 0x31 0x32 0x34 0x2e 0x32 0x32 0x00
0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0x02 0x03 0x00 0x00
ENABLED LOCAL
4bytes : Size (LSB first)
size of each file to rotate (file size is from 3 to 65535 KB)
1bytes : Rotate
Number of back-up files after logrotate (maximum 1 file)
To set the file size to 100 bytes, use the IPMI command:
ipmitool -I lanplus -H xx.xx.xx.xx -U xxx -P xxx raw 0x32 0x68 0x00
0x01 0x64 0x00 0x00 0x00 0x01
Default configuration restore
Use configuration restore to start the configuration from scratch. For example, use configuration restore to remove the old
configuration and start over if you reinstall the system or move the system to a new location.
Restore default configuration command
● NetFn—0x32
● Command—0x66
● Response byte 1—Completion code
Default settings
The following tables list the default settings after a switch restore.
Table 19. Default settings after a switch restore
Name Setting
BMC OOB Enabled for non-TAA and disabled for TAA
60 Configuration methods