Install Guide
Table Of Contents
- Dell EMC PowerSwitch Z9432F-ON Installation Guide August 2021
- Contents
- About this guide
- The Z9432F-ON switch
- Site preparations
- Z9432F-ON switch installation
- Power supplies
- Fans
- Management ports
- Secure boot
- Before you install an operating system
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union EMC directive conformance statement
- Japan VCCI compliance for class A equipment
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell EMC support
6. Attach the outer rail to the front of the four-post rack. The rail clicks into place.
7. Repeat these steps for the second rail.
8. Slide the inner rails that are attached to the switch into the outer rails that are attached to the rails.
NOTE: Press the spring clip on each inner slide rail to allow the switch to slide into the outer rail.
20 Z9432F-ON switch installation